NPS45 Napoleon Automated Pellet Stove - Discontinued
Napoleon · 1 document
About
THIS PAGE HAS BEEN DISCONTINUED, THIS PAGE IS UP FOR INFORMATIONAL PURPOSES ONLY
A renewable energy source, environmentally friendly, economical, convenient… these are just some of the reasons a Napoleon® pellet stove is the perfect solution to heat your home. The freestanding stove provides Zone Heating furnace performance and a reliable heating source. The NPS45 gives you uncompromising pellet performance year after year with the comfort of knowing you have selected a product made with true craftsmanship and advanced technological innovations.
NPS45 Napoleon Automated Pellet Stove Features:
- For maximum comfort, the NPS45 allows for convection blower adjustments, no matter what the heat setting is at
- Flashing light warns you when fuel is expended
- Fine-tuning adjustment modifies combustion air and/or pellet feed rate to the burn pot to compensate for poor quality pellets and/or venting variances
- Purge cycle (on start-up, shutdown and every 60 minutes) cleans the burn pot of residue depositing it in the ash pan
- From 8,000 to 40,000 BTU's (may vary depending on pellet quality)
- Concealed, large capacity ash pan
- FAILSAFE™ auto ignition and auger system allows you to start the fire quickly and easily
- Large 55 lb, easy-loading hopper for up to 55 hours of continuous, trouble-free operation (55lb capacity allows for a full 40lb bag of pellets to be added while 15lbs still remain in the hopper, eliminating the inconvenience of partial bags)go green
- Easy to access, automated control panel
- 3" or 4" pellet vent
- A Napoleon® Go Green environmentally friendly product: pellet fuel is a renewable resource
- Certified for bedrooms, bathrooms, bed sitting rooms and mobile homes
- President’s Limited Lifetime Warranty
Accessories
- Optional decorative ceramic log set
- Sandstone decorative brick or Porcelain Reflective Radiant panels
- Hopper extension
- Outside air kit with through the wall vent
Specifications
| Specifications NPS40 | |
| BTU Output | 8,000-43,000 |
| Hopper Capacity | 55 lbs |
| Area Heated (Sq. ft.) | Up to 2,000 |
| Burn Rate* (lbs/hr) | 1-5 |
| Burn Time* (low burn) | 55 hours |
| Flue Diameter | 3" |
| Electrical Rating | 115 Volts 3.6 Amps, 60Hz |
| Mobile Home Approved | Yes |
| Blower Kit Available | Included |
| THIS HEATER HAD BEEN TESTED TO | ASTM E 1509, UL 1482, ULC S627 |
| CLEARANCES | |
| (must be installed on a non-combustible floor protector extending 6" in front and both sides) | |
| Corner | Rear / Sides |
| 2" | 3" / 6" |
This model is no longer sold new. Its manuals stay here, and we still supply parts.
Photos






Need help with this?
We have sold and serviced these appliances since 1999. If you need a part or advice, call us.
406-300-1776