Napoleon NZ26 Napoleon Wood Burning fireplace -Discontinued — Owner's Manual

This fireplace has been discontinued due to stricter EPA regulations, all inventory has been sold. This is an informational page for those who have already purchased the unit. 

Designed for your home! 

The NZ26 Prestige® can be installed as a zero clearance or masonry fireplace. For your convenience it may be utilized for zone or multi-room heating and may even be connected to your central heating duct system. Heat output may be conveniently controlled with a wall thermostat. Clean burn is achieved with Napoleon's non-catalytic woodburning technology.

Features

• High efficiency and low emissions are achieved through a NON-CATALYTIC HIGH TECH design - You never have to replace a catalytic combustor to achieve a clean burn
• Uses outside or inside air combustion.
• Full refractory brick liner
• Four stainless steel secondary air tubes
• Firebox aerodynamics allow you to open the door without drawing smoke into the room.
• Heat radiating high temperature ceramic glass.
• Pre-installed, automatic, variable speed blower switch
• Heavy duty mig welded construction
• Safety tested and listed to Standards in Canada and the United States: ULC S610, ULC S627, UL 127 for zero clearance fireplaces and to S639 for solid fuel burning masonry fireplaces
• Cast iron grate with self-closing ash dump
• Large capacity ash pan with lid and dual carrying handles
• Easy, single lever combustion control
• President's Limited Lifetime Warranty